Onex&nbsp;<br /><br />
  • Home
    • The Sonex Workshop
    • Tools >
      • Piano hinge ruler jig
      • Cutting aluminum
    • Workshop
  • Onex Build
    • Wing attach
    • Electrical
    • Instrument panel
    • Controls >
      • Trim System
    • TAIL FEATHERS-Horizontal Forward Spar >
      • Horizontal Aft Spar >
        • Horizontal Stab assembly
      • Vertical Forward spar assembly &main (aft) spar assemblyy
      • Rudder and elevators
      • Tail installation ONX-T01
    • Wings ONX-W23 thru >
      • Spar -inboard
      • Spar Outboard >
        • Skinning and dimpling
      • Ailerons and Flaps
    • Fuselage F22 to F14 >
      • F13 to F1
    • Landing Gear >
      • Hydraulic / Toe Brakes
      • Nose Wheel
    • Fuel system
    • Windshield-Canopy
    • Cowling-upper& lower >
      • Engine Baffle
    • Paint ,Interior
  • Carb Heat Box
  • My Scott Casler Hummel 2400cc Install
    • First engine start
    • Quick comparison
    • Aerovee >
      • Prop/Hub failures
    • Revmaster
    • Great Plains and Hummel
  • Canopy
  • Trailer
  • Battery box
  • Inner wing build
  • Stuff
    • Bit And Pieces
    • Sonex plans
    • Flying movies
    • Pic's from other builders
  • Other sites
  • Video Hints
  • Written Hints
  • Problems avoided
  • Window shopping
    • Brakes
  • Oshkosh trips
  • Paint

Trim System

There's not a lot of information on the setting up of the trim specifically for the Onex  but what was there helped me enough ,along with pictures I had taken of the Sonex's Onex last summer at Oshkosh. A bit of trial and error and I think I have it about right but the true test will come when I go flying.
​Keep in mind I placed the trim control on my right as can be seen here........
Picture
I see the main advantage of this as always being able to know where the trim is set by simply looking at it.Arrows lined up = neutral
  • Click on a photo to enlarge
Picture
Here is a pic of Sonex's Onex trim layout