Onex&nbsp;<br /><br />
  • Home
    • The Sonex Workshop
    • Tools >
      • Piano hinge ruler jig
      • Cutting aluminum
    • Workshop
  • Onex Build
    • Wing attach
    • Electrical
    • Instrument panel
    • Controls >
      • Trim System
    • TAIL FEATHERS-Horizontal Forward Spar >
      • Horizontal Aft Spar >
        • Horizontal Stab assembly
      • Vertical Forward spar assembly &main (aft) spar assemblyy
      • Rudder and elevators
      • Tail installation ONX-T01
    • Wings ONX-W23 thru >
      • Spar -inboard
      • Spar Outboard >
        • Skinning and dimpling
      • Ailerons and Flaps
    • Fuselage F22 to F14 >
      • F13 to F1
    • Landing Gear >
      • Hydraulic / Toe Brakes
      • Nose Wheel
    • Fuel system
    • Windshield-Canopy
    • Cowling-upper& lower >
      • Engine Baffle
    • Paint ,Interior
  • Carb Heat Box
  • My Scott Casler Hummel 2400cc Install
    • First engine start
    • Quick comparison
    • Aerovee >
      • Prop/Hub failures
    • Revmaster
    • Great Plains and Hummel
  • Canopy
  • Trailer
  • Battery box
  • Inner wing build
  • Stuff
    • Bit And Pieces
    • Sonex plans
    • Flying movies
    • Pic's from other builders
  • Other sites
  • Video Hints
  • Written Hints
  • Problems avoided
  • Window shopping
    • Brakes
  • Oshkosh trips
  • Paint

Windshield

Picture
Preliminary fitting.
I had to relocate the factory holes at the bottom of the windshield bow so that the bow rested on the upper longeron's which lowered the windshield as the bow was pushing the windshield up to far.I cut the upper cowling to fit the edge of the windshield instead of trimming the windshield.

Picture